BANKSY

The display outside the box

Strikingly simple and modern, BANKSY is the new ultra-flat front-mounted display series for contemporary fixtures

PICK THE RIGHT BANKSY

BANKSY comes in 4 different models:

BANKSY DB1
Ideal as hall position indicator – Fits 55x55mm cut-outs – Perfect retrofit for older DMG D1 series display

BANKSY DB2
Larger version of the DB1 with 68mm x 71mm screen

BANKSY DB3
Ideal as car position indicator – Suitable to replace DMG DZ3 front mounted displays (139mm x 77mm)

BANKSY DB4
Framed version of the DB3 fitting a 79mm x 144mm cut-out

The BANKSY DB3 and DB4 can be completed with same sized capacity plates.

CTDB3 – 139mm x 77mm
CTDB4 – 144mm x 79mm

AT FLOOR OR IN THE CAR

The screen of the Banksy display can be provided with two different layouts depending on its destination:
For displays at floors: the screen is equipped with symbols such as Alarm bell, Car at floor (55×55 and 68×71 versions only), Out of service.

For displays in the lift car: the screen is equipped with typical EN81-70 symbols Alarm sent, Communication established, Overload.

RETROFITTING EXISTING DISPLAYS

The Banksy is designed to fit the cut-outs of some of DMG’s best-selling displays.

The DB1 can be used to retrofit the front-mounted, parallel versions of the DS and D13 position indicators manufactured by DMG since 2000. The new Banksy perfectly fits into the 54x54mm cut-out of the DS/D13 and the existing cables can be connected one by one to the terminals of the new display.

The DB2 and DB4 are suitable for retrofitting other displays on the market.

The DB3 can easily substitute the DMG’s Lagoon DZ3 LCD display in its front-mounted version.

Banksy DB1 retrofits the DS / D13 54x54mm displays

Banksy DB3 retrofits the 138x76mm DZ3 Lagoon
front mounted display

CONNECTION TO CONTROLLER

BANKSY displays are designed as multiparallel devices and can be connected to new and existing controllers in one of the following ways:

3 wires serial DMG: 3 terminals are available to display up to 29 floors (from -9 to 19)
1 line per floor: 11 terminals X01 to X11 are available for up to 11 floors, with the possibility to set the offset (from -3)
1 line per segment: 10 terminals X01 to X10 are available to display digits from -9 to 19
Gray / Binary: 6 terminals X01 to X06 are available to display up to 23 floors

In addition, 3 inputs with independent common (S1, S2 and S3) are available to handle service symbols, and 4 optoisolated inputs are there to handle UP and DOWN arrows.

YOU MIGHT ALSO BE INTERESTED IN

Raffaello

Matisse

TOOLS

Data sheet

Video